Effect of noise on output-only modal identification of beams
원문 초록
In most cases, structural health monitoring depends on the determination of the modal parameters of the first few modes of a structure. The data that are used to identify these modes by output-only methods include the structure response together with noise. The presence of noise in the structure response affects the modal parameters. The current study was undertaken to examine the possibility and accuracy of identifying the modal parameters of beams in the presence of noise. For this purpose, the modal parameters of the different modes of single-span beams were obtained using output data with different signal-to-noise ratios. The acceleration signals were obtained by transient analysis and then different powers of noise were generated and added to the signals. The modal parameters of the beams were obtained using output-only methods. Parameters having signal-to-noise ratios of greater than 13.98 dB for all modes considered were identified. At a signal-to-noise ratio of -6.02 to 13.98 dB (higher noise level), it was not possible to identify the modal parameters of the first mode of beams, but the parameters of the higher modes were identified with good accuracy.
함께 살펴볼 논문
공통 태그를 근거로 연결했습니다. 실제 인용 관계나 논문의 우수성을 뜻하지 않습니다.
Efficient dynamic modal load reconstruction using physics-informed Gaussian processes based on frequency-sparse Fourier basis functions
Response Estimation and System Identification of Dynamical Systems via Physics-Informed Neural Networks
Multitask learning for improved scour detection: A dynamic wave tank study
Foundation Models for Structural Health Monitoring
Exploring Challenges in Deep Learning of Single-Station Ground Motion Records
Classification of Various Types of Damages in Honeycomb Composite Sandwich Structures using Guided Wave Structural Health Monitoring
토론
이 논문과 연결된 포럼 글이 아직 없습니다.